Hi i woud like to know how to remove these black dots on some boards. There are chips under it right!
top of page
7 Comments
Gold-N-Scrap
Recovery & Refining of Precious Metals
bottom of page
Hi i woud like to know how to remove these black dots on some boards. There are chips under it right!
Setting aside time for regular solitude and https://www.lazyfit.ca/ introspection can enhance self-awareness and emotional wellness.
When you hire an injury attorney, you gain an Dog Bites advocate who will relentlessly pursue justice on your behalf.
Live broadcasts, like sports events and premium iptv award shows, create a sense of excitement and immediacy.
Investing in art and collectibles can be a passion-driven form of write for us investment. However, it's essential to be well-informed about the market and potential risks.
many thanks
I would remove the black mass from the PCB and try to treat it from the bottom. The material is very acid and temperature resistant. The values are zero to very little, so I doubt that it will pay off. The technology is called COB or chip-on-board. https://en.wikipedia.org/wiki/Chip_on_board
I did some of them, and they usually contain no PMs. COB is a low-cost technology to reduce costs. Makes no sense to use PMs here. Mostly, they will use Ni instead of PMs and Al bond wires.
It is a realy pain to remove.
This black epoxy is extremely hard and difficult to remove mechanicaly.
Either use air chisel, incinerate or simply leave it alone.